For Windows users, insert the CD that came with your printer and run the setup. If the WPS wireless setup is still failing after following this guide, please contact us for further assistance.ġ.
#Canon mg3500 reset wifi manuals
If you do not have the installation CD that came with your product, please download the manuals and software to continue.
#Canon mg3500 reset wifi software
Please now proceed by installing the software to make the most out of your PIXMA MG3550. When referring to the printout, check that the “Connection” indicates “Active” and that the SSID - Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network. The network information page will be printed. Press & hold the button until the alarm lamp flashes 15 times, and then release it. Load a sheet of A4 or letter-sized plain paper.ģ. Make sure that your printer is turned on.Ģ. To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer if you wish:ġ. When the printer has successfully made a connection to your wireless network, the power and Wi-Fi lamp will stop flashing and remain lit. The (blue) Wi-Fi lamp on the printer will continue flashing while searching, and the power and Wi-Fi lamp will flash when connecting to the access point.
![canon mg3500 reset wifi canon mg3500 reset wifi](https://www.canon.co.uk/media/2-19_tcm14-1109502.png)
Make sure that the lamp next to this button starts to flash blue and then go to your access point and press the button within 2 minutes.įor exact details on starting WPS on your access point, please refer to its user guide. Press & hold the button on the top of the printer until the alarm lamp flashes once. Most WPS enabled access points use this protocol. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. If the WPS push button is not available please use the instructions in the Standard Connection Method. Please check with your device’s user guide for details. The access point must have a physical WPS push button available. If your product issue was not resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your technical support options.Before we start, there are some conditions that must be met in order to use the WPS push button method: The printer is now connected to your wireless network. Make sure that the Wi-Fi lamp (blue) of the printer is lit. When the wireless connection has been established, the LED (Light Emitting Diode) lights up for about 3 seconds, then changes to "1" as shown in the illustration below. The middle segment is lit in the illustration below. The bottom segment will flash, then the middle segment, followed by the top segment. Make sure that the the LED (Light Emitting Diode) begins flashing. Please refer to the documentation that came with your wireless router for instructions on entering this informaiton.
#Canon mg3500 reset wifi code
You will need to enter the PIN code into the router's internal settings.
![canon mg3500 reset wifi canon mg3500 reset wifi](https://www.canon.dk/media/2-14-1_tcm81-1631226.png)
The wireless connection setting information including the PIN code will be printed. Make sure that the bottom segment of the LED (Light Emitting Diode) flashes. Press and hold the Maintenance button (A) on the printer (for about 5 seconds). Make sure that the LED (Light Emitting Diode) is lit as shown in the illustration below. Follow the steps below to use this method to establish a wireless connection between the printer and your network. You can connect your PIXMA MG3120 / MG3122 to a wireless router by entering the printer's WPS PIN code into the router's internal settings.